Thanks Merle!
That was a good explanation of what I was experiencing. I like version 2
firmware, but will try v1.373b5. I've tried it before, but never for long
enough to get used to it.
73 de K1ESE
John
----- Original Message -----
From: "Merle Bone" <merlebone@charter.net>
To: <tentec@contesting.com>
Sent: Sunday, May 11, 2008 3:15 PM
Subject: [TenTec] AGC Threshold, RF Gain, Volume
> John,
> Yes the RF gain control changes the AGC threshold level - just like
> setting
> it in the AGC menu. One of the original Orion firmware developers, Doug
> Smith, wrote in a paper describing the Orion Digital AGC System:
> -----------------------------------------------------------------------
>
> "In digital AGC systems, it is relatively easy to provide a variable
> threshold or "knee." Input signals below the threshold do not actuate the
> digital AGC and are not compressed. At thresholds well above the receiver
> noise floor, a receiver therefore gets quiet when only puny input signals
> are present in the passband. At thresholds near the noise floor, all
> signals
> are boosted to meet the output-level criterion. The net effect of a
> variable
> threshold is very much like that of an IF gain control."
> ------------------------------------------------------------------------
>
> Consequently, if you "ride the RF gain" and set it for a good audio level
> on
> a stronger signal, weaker signals will not activate the AGC and they will
> be
> too low in volume. I've never been fond of this process. I think it was a
> "crutch" to offset the gain distribution issues in the new Orion V2
> firmware. There was an AVC loop in the V1 code that prevented the audio
> stages from being overdriven and distorting. That code was taken out of
> the
> V2 firmware and there have been peak signal distortion issues since. That
> started some people doing what you described with the audio and RF gain
> controls. Unfortunately you are seeing some of the unintended consequences
> of operating the radio like that. Hopefully Ten-Tec will address the
> distributed gain level issues in the next Orion V2 firmware release -
> maybe
> they will put the ALC code back.
> 73, Merle - W0EWM
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|