Thanks for the response Ed.
By the Matrix, are you referring to the option menu setup? I'm not quite sure
what you mean.
Thanks, Al
-------------- Original message --------------
From: Ed <w3nr@comcast.net>
> albrooks7@comcast.net wrote:
> > I have used HRD with my 756 PRO with no problems. I tried to use it with
> > the
> OMNI VI ver.3 with no luck. I am trying to use the 1/8" phone plug on the
> OMNI.
> I have tried it with the 301 remote plugged in or not plugged in. It doesn't
> seem to make a difference. I tried using the HRD parameters for both Ten Tec
> and
> also the Icom 735.
> >
> > I've tried different baud rates and that doesn't seem to make a difference
> either.
> >
> > I am using a generic USB interface cable that works fine on the Icom.
> >
> > Anybody have any experience with this? Any help will sure be appreciated.
> >
> > Thanks, Al K9XR
>
>
> Make sure they are both set to the right hex address.....04 and the rig
> matrix is turned off in the menu in the Omni.
>
> Ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|