Hi all,
I'm getting into my Omni VI to try to find why the TX power is low on
1.8 MHz, but not so low on 2.3 MHz. I ant to look at the TX PA and the
Lowpass Filter Board. Having removed both the top and bottom covers from
the rig, it is not yet obvious how I can get to the areas I want to
inspect. How should I get there? Remove the top panel which has the
speaker mounted on it? Or remove the bottom panel? Or will I need to
remove both? What if I need to remove the whole PA assembly (if I decide
I need to replace the PA transistors), it appears to be screwed to the
back panel. Can I remove it from the back panel, leaving the back panel
in place? Or do I have to remove the whole back panel?
Thanks in advance for any help,
DE N6KB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|