Bill:
I think I have a 509 Manual if you would like I will scan it and convert to a
PDF file and email it to you.
In fact I have copies of most all the Ten Tec Gear manufactured in the 70's and
80's.
73
Jim Younce K4ZM
-------------- Original message --------------
From: "Bill Ames" <billa@aob.com>
>
>
> I have finally located some of the "green" non toxic cleaning stuff (thank
> you to all who pointed me in this direction) and obtained some cotton balls.
> Next is the removal of the knobs. I do not have a manual for this rig but I
> am sure that there is some important information I should know before I
> attempt this next step. I would like to know what type/size tool I will need
> to properly access the knob set screws; I don't want to strip them. I should
> probably take the cover off and see if anything is living in there :-( but I
> don't think so. Any suggestions are appreciated.
>
>
>
> Bill
>
>
>
> KB1LG
>
>
>
> Bill Ames
> Analytica of Branford, Inc.
> 29 Business Park Drive
> Branford, CT 06405
> PH: (203)488-8899 xt 337
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|