Hi Paul
Tnx ,I'm finding it out now about the drive setting,I went thru all the
diodes on the swr board and pre drive board,Two were bad on the swr
board,thus low receive,receive is fine now.i set r21 down abit it seemed
set too high from previous owner peaking at over 20 amps now it is
around 17 18 amps on transmit.....great radio on the receive and on cw
wow....ssb too is ok,i realize it is not like my Kenwood TS-50,but I
really think the receiver on the omni-d has a more pleasing receive
audio,clearer more natural sound to it...I got this radio as a wim or
play with radio here in the shack,really nice condition except for a
ding on the lower corner bezel metal band.quite stable too.
tnx Mike
Paul DeWitte K9OT wrote:
> Mike I have an Omni C. I used if for many years before upgrading to a Corsair
> II.
>
> The drive setting on mine is not the same for every band. On SSB you want the
> alc light to come on, on voice peaks. If it is lit all the time that you are
> talking you have the drive set too high.
>
> Ask someone that you have in QSO to give you some feed back on voice quality.
> If you have the drive set too high you will sound muffled (for lack of better
> description) and be hard to understand.
>
> The Omni is a great rig. Especially on CW. On CW set the drive to where the
> alc just barely comes on when you key it.
>
> For a new ham this has to be one of the best rigs out there for the money,
> and could not be simpler to operate.
>
> Good luck 73
> Paul K9OT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|