TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec 238A settings?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec 238A settings?
From: Stuart Rohre <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 11 Apr 2008 14:36:31 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
MFJ does have a variety of balanced line tuners.  Check out their 
current catalog.

On the subject of the tuner being balanced itself, L. B. Cebik, noted 
antenna guru, (W4RNL)  has modeled that even the end fed so called Zepp 
Antenna may have only 10 per cent imbalance with one of its parallel 
feeders open circuit at the antenna, and the other connected 
traditionally to the end of the wire.  Others have reported good 
matching using L networks to match even a balanced antenna feeder.  Due 
attention in any tuner and its application is to present the tuner with 
a length of feeder that does not shift the impedance to be matched too 
high or low for the range of the tuner.  Primarily avoid odd multiples 
of quarter wave feeder at the band in use.

-Stuart
K5KVH


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>