Doug,
The 302 remote encoder is great with the internal voice keyer on my Orion.
You can program the 3 F keys to send the 3 voice messages. I use it in every
SSB contest.
Don
NT0F
----- Original Message -----
From: "Doug Turnbull" <turnbull@net1.ie>
To: <tentec@contesting.com>
Sent: Friday, April 04, 2008 3:12 PM
Subject: [TenTec] Interfacing a MFJ 434B voice keyer to an Orion 2
> Has anyone interfaced the MFJ 434B Voice Keyer to the Orion 2? If so I
> would be grateful to know the MFJ internal jumper settings you used for
> the
> Orion 2. The ten volts output from pin two of the front mike
> connector
> concerns me. I do not use this voltage as my microphone is a TenTec 708
> or
> a Heil Proset Plus both of which are dynamic microphones. The TenTec
> grounding recommendations are also of concern.
>
>
> This past weekend I used the voice memory in the Orion 2 for the CQ WPX
> contest for the first time since purchasing the Orion 2 in August 2006.
> It
> is a great help for an OTs voice. The disadvantage is that the send 3
> button is very close to the user 1 button and twice I inadvertently hit
> user
> 1 causing the Orion to reset to another state - what a pain. This is a
> switch which one needs to hit without worry. The SEND 3 switch is not
> convenient on the front panel of the Orion 2 when the O2 is propped up to
> give a better angle of view for the display screen. I wonder if the
> remote
> control pod would not be useful in this respect - any of you good people
> have comments on this?
>
> On occasion I found that my transmission was weak while using the Orion 2
> Voice Memory and had to hit the button a second time to correct for this.
> I was using the Orion 2 monitor function at a low level to monitor my
> voice
> and so noticed this problem. This was not a severe problem. I used the
> voice monitor because I am not yet comfortable with VOX and also find the
> monitor helps me to keep my voice under some control in the contest
> environment - a low voice level is all that is needed with the Proset Plus
> boom mike.
>
>
>
> The reason for wanting the voice keyer is that it will retain the voice
> keyer memory when powered off and also that it has a greater storage
> facility. Similarly I use an external GHD GK509 CW memory keyer because
> it
> allows programming via a straight key, has greater memory capacity and
> sits
> flat on the desk allowing easier finger tip operation. I would
> appreciate
> comments on the wiring of the MFJ voice keyer and also your experiences
> with
> the internal voice memory capabilities of the O2. Despite problems I was
> grateful this past weekend for the facility.
>
> 73 Doug EI2CN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|