On Thu, 2008-03-20 at 16:59 -0700, Woody Hester wrote:
> My Corsair II often will not load more than 5-10 W & the receive signal is
> weak. When I gently slap the rig on the right side it comes up to full power
> and the receive signal comes to normal. I'm going to open it up this weekend
> to look for loose connections, cold solder joints etc. I'm a hobbyist
> (business major) so any advice re: what to look at first appreciated. The
> rig was brought up to factory specs / aligned by TT about 4 mos. ago, was
> given a clean bill of health and performed flawlessly until this developed
> recently. Happy Easter to all! Woody / WD9F
>
Check the interconnecting cables and pins. They have caused problems
before.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|