Scott,
I would look around the heterodyne crystal for 40 m or perhaps the
crystal itself is bad.
73,
Bob WB2VUF
scottsheppard@videotron.ca wrote:
>
> I have an issue with my Omni V. It now seems when I turn it on (cold) I do
> not get a receive signal on 40. If I hit any of the other band buttons the
> receiver comes to life, back to 40 nothing. After about two minutes it
> finally comes on. I have done the little switch check at the back to no aval
> and given the other bands still work it is most likely not it. I have poked a
> proded but nothing yet. This is a relatively new issue. Again, only on 40.
> Any suggestions appreciated.
>
> 73 scott VA3IED
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|