TenTec
[Top] [All Lists]

Re: [TenTec] Titan 425 shelved for 10 years

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Titan 425 shelved for 10 years
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 18 Feb 2008 21:20:42 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I'd say as good today as it was 10 years ago.  Now as to the electrolytic 
caps........ they are another story.  Likely they will need immediate 
replacement.  Also the fan will need cleaning and a lube job.  If you so 
choose to power it up, do so with a Variac at about 10 volts per minute 
until you reach line voltage.  Listen for any unusual noise and watch for 
smoke.  Should, at any point, you observe a large and loud explosion, first 
obtain laundry service for your trousers, and then prepare to clean the 
inside of the power supply area and then replace all the electrolytics.

73
Bob, K4TAX


----- Original Message ----- 
From: "DC" <daclark56@hotmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 18, 2008 9:10 PM
Subject: [TenTec] Titan 425 shelved for 10 years


> How good is the final tube in a Titan 425 thats been un-used for ten 
> years?
>
> thank you
> 73
> KD8Z@ARRL.NET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>