TenTec
[Top] [All Lists]

Re: [TenTec] Frequency Misalignment Between VFO A and VFO B

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Frequency Misalignment Between VFO A and VFO B
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 18 Feb 2008 08:36:33 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
My N4PY Orion Software has a procedure to do this.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Kim Elmore" <cw_de_n5op@sbcglobal.net>
To: "Tentec Contesting List" <tentec@contesting.com>
Sent: Monday, February 18, 2008 8:32 AM
Subject: [TenTec] Frequency Misalignment Between VFO A and VFO B


> For some  time, I've noticed what seemed to be a very slight 
> frequency misalignment between VFO A and VFO B when in the binaural 
> mode (A in one ear and B in the other).
> 
> On my O II it's noticeable even in the noise as what sounds like a 
> beat note in stereo phasing when both VFOs are tuned to the same 
> frequency. Last night, I chased this down and found that VFO B is 
> about 6 Hz lower in frequency that VFO A. This isn't a terribly big 
> deal, but is there a way to align the two, or are the master 
> oscillators different so that the two drift around slightly as a 
> matter of course?
> 
> Kim Elmore, N5OP
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>