Just reduce the RF gain enough to get rid of excessive band noise and
operate the rig normally. I run mine with RF gain at about 95 but this
varies greatly with band noise and antenna. I usually have the preamp on
but again this vaires with band noise. I never use NR. I run my AGC at
medium or slow.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, North Carolina 28635
----- Original Message -----
From: "Al Gelders" <agelders@lightspeed.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 04, 2008 2:46 PM
Subject: Re: [TenTec] ORION II CW pile up readability related question
> Having followed this thread from end to end I spent the weekend trying
> various combinations of AF/RF gain on my Omni VII. I ended up turning
> up the AF gain, turning on the preamp and using the RF gain to control
> output. On 20M I ended up having to turn on noise reduction to 9. At
> that point I thought I might be getting a bit of improvement but I
> haven't spent enough time to be sure.
>
> So, has anybody spent enough time with the Omni VII to suggest the best
> combination of all of these parameters?
> Thanks, Al KI6NRE.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|