I am always amazed at how effectively very weak PSK transmissions are
decoded by the software. I attribute this in part to the very narrow signal
bandwidth, which as you all know, concentrates the power into a narrow slice
of spectrum. This is inherently effective, and since PSK31 is very narrow,
it is nearly as effective in this way as CW. Not quite.
The other part comes from the software and filters. A narrow mode like this
allows you to use very effective filtering, especially with the software.
And then, the noise reduction algorithms can be very effective.
Bottom like ? Reduce power. Be amazed :) ((And better antennas are of
course better than more power any day))
73 de Gary, AA2IZ
----- Original Message -----
From: "ron" <roncasa@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 02, 2008 10:42 AM
Subject: Re: [TenTec] Digital (PSK31) Communications
> Henry Mackey wrote:
> >
> > The power setting on the Jupiter was at 100%. However, I would reduce
the power according to the rigs meter to 20-25 watts and avoid any ALC.
> >
> >
>
>
> 25 watts??
>
> For a mode that only needs minimal wattage??
> Try less and be amazed. (the spectrum would also be cleaner if we all did)
> (smile)
>
> Ron
> "the 516 is a keeper"
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|