Hams are tweakers. We tweak this and tweak that in an effort to get it
better. I repair "over tweaked" radios on a regular basis. There's nothing
like having to replace 3 or 4 coils with busted slugs.
Alignment of the Omni VI series is not difficult "IF" and that's a big if,
you have the experience and documentation and test equipment required. If
you don't, then it becomes a science project with unknown results. I've
aligned several of these very successfully. My manual has voltages, test
points, waveforms and such that have been entered and obtained by me from
known good working circuits. The PLL's have a lock pulse that is difficult
to see even with a 250 MHz scope. It's fast. Miss that one and you're in
deep trouble as Dan says.
Best thing, take advantage of the economical, fast and excellent Tentec
Service department. You won't regret the investment of a few dollars to get
it done completely correct.
73
Bob, K4TAX
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Monday, January 07, 2008 7:48 AM
Subject: Re: [TenTec] Omni VI XTAL OSC problem
> Steve, I would save any alignment for last.
> Look for a bad component first.
> You are going to pay hell with that rig if you start turning pots without
> service information that you can't get from Ten Tec.
> If you do I will bet you the rig will end up in the Ten Tec service
> department because you will never be able to get it back to factory specs.
> If you had a service manual I would say tweak all you want.
> Dan/N4VET
>
>
>
> **************Start the year off right. Easy ways to stay in shape.
> http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|