| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Nother' discovery about the Corsair & Titan |
| From: | Steve Berg <wa9jml@tbc.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 31 Dec 2007 19:00:39 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
I tried to set up my Corsair II with my Elecraft transverters. It takes about 3-4 watts to drive them to the output levels required by my Mirage brick amplifiers on 6 and 2 meters. I can readily use my Argonaut II and the Omni V with the transverters, but when I use the Corsair, I have problems on SSB with voice peaks overloading the transverters, while the average power is fine. Is this something that I can correct with the ALC control? Thanks, Steve WA9JML _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] TX en and TX out, OTAKEBI |
|---|---|
| Next by Date: | Re: [TenTec] Nother' discovery about the Corsair & Titan, Bob McGraw - K4TAX |
| Previous by Thread: | Re: [TenTec] Nother' discovery about the Corsair & Titan, Bob McGraw - K4TAX |
| Next by Thread: | Re: [TenTec] Nother' discovery about the Corsair & Titan, Bob McGraw - K4TAX |
| Indexes: | [Date] [Thread] [Top] [All Lists] |