When I wrote that I knew I should fire up the Orion II and check the menu
setting
Its in the 'other' menu - FSK Tx Data - choices are either mark hi or mark
low. In normal RTTY parlance, It's normal or reverse. For my setup, Mark
High gives me normal RTTY (with MODE set to FSK). If you have it reversed
(Mark Low), and send a CQ, someone will come back and tell you your signal
is reversed and it's this setting you change. Receiving is not a problem -
just press the Rev button in MMTTY and flip a switch on your TU and you're
OK. Depending on how I set up the RigBlasterPro, this setting sometimes
needs to be reversed.
Dave K5WNV
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Duane Calvin
Sent: Wednesday, November 21, 2007 5:12 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] rtty
Dave,
What "normal/reverse" are you describing?
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of David W LeJeune, Sr
Sent: Wednesday, November 21, 2007 4:37 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] rtty
Hi, Folks
I have had very good success running the Orion II on rtty. I use a
Rigblaster pro to key the FSK line and provide audio to the computer for
MMTTY. MMTTY with the EXTFSK 1.05 MMTTY plugin does a great job of
providing FSK keying for the Orion II. I use the FSK mode on the Orion II
with bandwidth set to 750. Only real problem is to remember whether to set
the normal/reverse to the right setting on the Orion II.
Dave K5WNV
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John
Sent: Wednesday, November 21, 2007 12:31 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] rtty
Good question Steve I am in the same boat as you are I have the Orion II and
would like to work rtty but have no success doing so . John kb2huk
----- Original Message -----
From: <W1dxh@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, November 20, 2007 9:40 PM
Subject: [TenTec] rtty
> what is the best way of using the orion for rtty? cabling soundcard etc.
> i
> have the aea pk 232. should i use it or do something different. any and
> all
> info appreciated, this will be a new mode for me.
>
> 73's tnx,
> steve w1dxh
>
>
>
> **************************************Check out AOL's list of 2007's
> hottest
> products.
> (http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|