Don,
Is the resistor REALLY a 70-ohm? Or, should it be a 70K ohm? 470-ohm?
70-ohm seems so low for a circuit suing a 10K pot for the AF Gain.
73 Bill N4LG
At 07:00 PM 11/18/2007, you wrote:
>For Art ,K0RO,
>
>I copied an article in Contesting.Com that modified the range of
>the AF pot
>in the OMNI 6+.
>
>This originated from Mark, K8VF, and I will pass it along to you
>and any
>others who want to do this.
>
>Don, ve1bn@eastlink.ca
>
> > Put a 70 ohm , 1/8 watt resistor between wiper and af min on
> audio pot at
> connector 55 on Lower pot board.
>
> Did this on Lower pot board as it was easiest, you could pull
> the if/af
> board, too but I did not.
>
> Flip rig with bottom off and front toward you.
>
> Lower pot board is on right front...connect 70 ohms(or so)
> between 2nd and
> 3rd solder trace counting from the left.
>
> Works like a charm. Normal audio level is at 12 o clock now
> instead of 7 o
> clock........
> I didn't have to pull any boards either.
>
> I can only guarantee this on my rig, not responsible for yours.
>
> Best regards.<
>
> Mark
> K8VF
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|