Thanks!
----- Original Message -----
From: "VE1BN" <ve1bn@eastlink.ca>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, November 18, 2007 6:00 PM
Subject: Re: [TenTec] Omvi VI AF Gain Control & RIT
> For Art ,K0RO,
>
> I copied an article in Contesting.Com that modified the range of the AF
> pot
> in the OMNI 6+.
>
> This originated from Mark, K8VF, and I will pass it along to you and any
> others who want to do this.
>
> Don, ve1bn@eastlink.ca
>
>> Put a 70 ohm , 1/8 watt resistor between wiper and af min on audio pot at
> connector 55 on Lower pot board.
>
> Did this on Lower pot board as it was easiest, you could pull the if/af
> board, too but I did not.
>
> Flip rig with bottom off and front toward you.
>
> Lower pot board is on right front...connect 70 ohms(or so) between 2nd
> and
> 3rd solder trace counting from the left.
>
> Works like a charm. Normal audio level is at 12 o clock now instead of 7
> o
> clock........
> I didn't have to pull any boards either.
>
> I can only guarantee this on my rig, not responsible for yours.
>
> Best regards.<
>
> Mark
> K8VF
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|