Hello Ed,
I had a similar problem with my original Orion.
I solved it by opening up the front panel and removing the battery for
about 10 seconds.
That restored normal operation for me.
Good Luck!
Mike
NM7X
~ Original Message ~
Date: Sun, 18 Nov 2007 09:20:51 -0500
From: "Ed" <w3etc@thecumminsgroup.com>
Subject: [TenTec] Help with Orion II Update
Hello Group:
I am in need of some assistance. I went to update my Orion II, to the 2039J,
last night and didn't get very far. I have updated it before with no
problem, but this time it would not update and the Orion screen displays up
to Program Flash 26 and then stops. The software only executes to line 30.
To make it more fun the radio will not perform a Master Reset and when you
turn it on it just displays the Ten Tec logo.
So it is stuck in a non operational mode. It will go back in the flash
update mode but that is it.
Hopefully it is not time for a trip home !
Any suggestions would be appreciated.
Thanks
Ed W3ETC
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|