Check all of your pin connections.
I have a bad pin in my connector from the 263 to the Corsair, and if it gets
bumped, I lose the VFOs altogether, or I have a similar funky LED display.
I adjust the pin & wire back to where it should be, problem goes away.
This may not be your problem, but it's a good place to start!
73
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of JMO1241@aol.com
Sent: Tuesday, October 30, 2007 10:16 PM
To: tentec@contesting.com
Subject: [TenTec] Corsair remote VFO 263
I have a problem with my Ten-Tec remote VFO-263 it seems to work fine for
a
while and then goes off frequency about 5 to 9 kc then when I readjust it
to
the correct frequency the voices sound like they are under water and
distorded. If I switch back to the 560 that is fine. Once this happens if I
switch
back to the VFO it is still distorted with both on the same frequency ???
Then
after an hour or so it's ok for a while.
Has anyone else had this problem and what was the fix ???
Thanks
John KA2VBT
************************************** See what's new at http://www.aol.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|