Gary,
I am on the road, and so I don't have access to schematics.? But if memory
serves, there is a set of band-grouped switching diodes on one to the boards (I
can't even remember which).? I'd bet you've lost a diode there.? It was pretty
easy to figure out which one when I looked at the schematic.
Bernie K5XS
-----Original Message-----
From: Ed <w3nr@comcast.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Wed, 24 Oct 2007 6:47 pm
Subject: Re: [TenTec] Omni VI Plus Issue on 160 and 10
Gary Grogg wrote:
> Just discovered that my Omni VI Plus is not receiving or transmitting on 160
> and 10 Meters. All other bands and modes are working normally. Before
> sending to the great workbench in the Smokies, any suggestions?
>
>
>
> Gary K4VIG
>
Good excuse for a trip to TT. I had the same problem on 160...plus there
are several good fishin spots
Ed
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! -
http://mail.aol.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|