TenTec
[Top] [All Lists]

Re: [TenTec] bringing up an old amp

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] bringing up an old amp
From: "Gary Hoffman" <ghoffman@spacetech.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 13 Oct 2007 01:14:50 -0400
List-post: <mailto:tentec@contesting.com>
Stuart,

Yes, I've seen those switches.  But neither of my two amps are so equipped.

But I understand that what is meant is truly disconnecting the HV.

That's the point I guess.

Gary

----- Original Message ----- 
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>;
<geraldj@storm.weather.net>
Sent: Saturday, October 13, 2007 12:39 AM
Subject: Re: [TenTec] bringing up an old amp


> Gary,
> Most amplifiers have a "power" switch that brings up the filaments, and a
> separate "standby-operate" switch that brings up the B plus to the plates
of
> the finals.  You leave the plate voltage switch in "Standby" position,
with
> filaments on only.
>
> -Stuart
> K5KVH
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>