OK, I'm now thoroughly confused.
I have finally recovered (I think) from a lightning strike I
experienced earlier this summer. It took out my O II, computer,
antenna switch and the balun on my 80 m vertical dipole (a F12 Sigma
80). Save for a bad rotator (that has nothing to do with the
lightning strike) everything seems to be fixed now and the ARRL
insurance really did spring for another O II (up to the insured value
of the old one, which was set at the older price). The new O II came
with 2.039d installed, so the firmware is the latest available version.
So, here I am, playing with Ham Radio Deluxe and I plug in 10.000000
MHz into VFO A (the main rx), intending to plug it into VFO B. Lo and
behold! VFO A goes to 10 MHz and I hear WWV! With the Main tuning
knob, I can't go below 10.050000 MHz, yet here I am. Curious, I start
tuning with all over the place with HRD and the O II dutifully goes
there and appears to work (though I don't know with what
characteristics). It also appears to transmit into a dummy load
(using he internal tuner) around frequencies close to the ham bands.
I didn't try anything way outside the ham bands (8 MHz, 20 MHz, 27
MHz, etc.). I do note, however, that the main tuning knob is not
functional when tuned outside the "normal" limits. As soon as I enter
a frequency that is in the normal limits, the main tuning knob
functions properly.
I can enter nonsense frequencies, like 90 MHz or 0.1 MHz, but I can't
tell if the rx works and I did not try transmitting there.
I admit to being pretty self-absorbed over the summer, dealing with
all sorts of family issues, so I must have missed something on the
reflector. Is this common knowledge? What's really going on?
Oh, and yes: I hear the garbage on 14.220, too.
Kim Elmore, N5OP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|