Jerry- On 1st look what you have laid out is correct. The only change
I would make, is to "wire around" the amplifier in the mic. It
certainly is not nedded (Or wanted, in my opinion) for your Delta.
Greg, KC8HXO
--- Jerry Colton <cornerman@comcast.net> wrote:
> Hello Ten Tec folks - I am looking for a little help wiring a D104
> TUG 9 amplified mic to my Ten Tec 580 Delta. If someone could help
> me, it sure would be appreciated.
>
> Here's what I have:
>
> Ten Tec (banana type connector) starting from tip down.
>
> 1.. PTT is the tip
> 2.. Mic signal Band
> 3.. Barrel is the common GND
> So I have the 3 lugs to connect to.
>
>
>
> On the D104 I have the following:
>
> 1.. Blue & Shield is common
> 2.. White is Mic or Audio
> 3.. Red is TX
> 4.. Black is RX
> 5.. Yellow is not used
>
>
> I have, for years, had trouble understanding mic wiring. I am
> assuming that Red is (1) PTT and would go to the Tip of the
> connector, and Blue and Shield would go to (3) common GND..?
>
>
>SNIP
Registered Linux User #440152
____________________________________________________________________________________
Got a little couch potato?
Check out fun summer activities for kids.
http://search.yahoo.com/search?fr=oni_on_mail&p=summer+activities+for+kids&cs=bz
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|