| To: | <kd3jf@arrl.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] delta 580 on 10 meters? |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 7 Sep 2007 16:32:58 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
You can open up a mike plug and the shielded wire will be the mike audio.
Or if there are two shielded wires, try putting the meter across them, and
blow into mike or whistle. The AC meter should show some millivolts if the
mike is working.
You need to get the manual for the radio, so you can see if the mike is wired wrong for this radio. Very likely. GL, StuartK5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] delta 580 on 10 meters?, Bob McGraw - K4TAX |
|---|---|
| Next by Date: | [TenTec] FS Filters & acc.., Richard Detweiler |
| Previous by Thread: | Re: [TenTec] delta 580 on 10 meters?, Paul Gates, KD3JF |
| Next by Thread: | Re: [TenTec] delta 580 on 10 meters?, d . e . warnick |
| Indexes: | [Date] [Thread] [Top] [All Lists] |