Thanks Bob for offering to take out that setscrew...
I have a full set of Allen wrenches, both Imperial and Metric....
Now that I know its an Allen head, I will fiddle with it till I get the knob
off...
my thanks for the info....
(even with a flashlight, I cant see down that little hole in the side of the
knob) hi..
73
Dennis
From: "Bob Towers" <mm0rkt@beeb.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, August 28, 2007 5:27 AM
Subject: Re: [TenTec] set screw
> Dennis wrote:
> > good evening group...
> > can anyone tell me the size and type of setscrew used on the main tuning
knob of the 580 Delta ??
> > tnx
> > 73
> > Dennis - VE3VG
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> I have an Argonaut II, which is the QRP version of the Delta. I have
> recently had the front panel off, which required the removal of the
> tuning knob. If you don't get any other replies, I'll take the screw out
> and measure it as best I can. It needs an Allen wrench (can't remember
> the size, but again I could measure it) to get it out.
>
> 73
>
> Bob
> MM0RKT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|