Ron,
Thanks very much for the information.
73,
Dave K8MN
Ron Castro wrote:
> I think you are describing R340, the meter calibration pot. You'll find it
> in the schematics for the original Orion in the A7 group, 81917_10.pdf.
>
> Ron Castro
> Chief Technical Officer
> Results Radio, LLC
> N6IE
> www.N6IE.com
>
>
> ----- Original Message -----
> From: "Dave Heil" <k8mn@earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, August 17, 2007 10:17 PM
> Subject: [TenTec] Orion - What's this trim pot?
>
>
>> I'm finally getting around to doing the sweep mod on my Orion. I
>> removed the covers this evening. I know about the master transmit audio
>> gain pot and the contrast post under the lip of the front panel.
>>
>> Can someone tell me the function of the pot which is behind the top edge
>> of the front panel and visible after removing the top cover? There is
>> an access hole for it on the black, ventilated metal strip just behind
>> the panel.
>>
>> 73,
>>
>> Dave Heil K8MN
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|