There is no single right answer to the question.
Saw already a couple of good recommendations, but, if you only want to
support the ends of the dipole, I would go with the cheep Kevlar stuff from
Radio works - about $20 for 200 ft. spool. It may also be OK for supporting
the feedpoint of the dipole, if you are NOT using a pulley. It is too thin
to use with most pulleys. It is more than strong enough and I have had it
up for years with no problems.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of lunenburg@juno.com
Sent: Wednesday, July 04, 2007 7:09 PM
To: tentec@contesting.com
Subject: [TenTec] antenna
A little off topic. I have to replace the rope holding up my 204'
dipole. Anyone have suggestions as to the best type to use?
Thanks,
KS2S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|