A little "bug" popped up this evening running V2.062a. I've run this firmware
for a few days without any "strange events." However, tonight I
found that every time I clicked on a computer spot, which caused a change of
band, and sent a frequency command to the Orion, the RX antenna was turned on
for the main receiver (Bands were not programmed in Orion for RX antenna). I
checked two different transceiver control programs and got the same response to
any change of bands on a new frequency command. I did a Master Reset on the
Orion and the problem disappeared. You may want to watch for this if you are
running V2.062a and you notice that the input signals take a big drop if you
change bands from a computer spot.
73, Merle - W0EWM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|