I misread the topic. My comments refer to using the Omni VII with my
program, not Omni VI.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, June 13, 2007 1:24 PM
Subject: Re: [TenTec] Squelch onn Omni VI
> Under program control, using my N4PY control program, squelch works in all
> modes. And my program can handle the transverters very well including
> automatically reducing power to the transverter drive level and displaying
> the real frequency.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "Darrell W4CX" <w4cx@bellsouth.net>
> To: <TenTec@contesting.com>
> Sent: Wednesday, June 13, 2007 10:38 AM
> Subject: [TenTec] Squelch onn Omni VI
>
>
> > I'm thinking about using some high-quality transverters (elecraft) for
> > VHF/UHF work using my Omni VI as 28Khz IF strip. But I discovered that
> the
> > Omni's squelch only works on FM. I couldn't bear listening to white
noise
> > all the time waiting for the bands to open, and I'd rather not have to
> > switch to FM for monitoring. Does anyone know of a way to enable
squelch
> on
> > SSB/CW on the Omni VI? Any thoughts on this approach? 73, Darrell W4CX
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|