To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Gauge of wire from power supply question? |
From: | "Paul Gates, KD3JF" <pearly732003@yahoo.com> |
Reply-to: | kd3jf@arrl.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 6 Jun 2007 12:59:50 -0700 (PDT) |
List-post: | <mailto:tentec@contesting.com> |
No. 10 wire is too big. MICHAEL SOUHRADA <wb9iog@msn.com> wrote: Dan FYI I use some brass tubing to do that. Takes a bit of fiddling but I had some old brass ball pen tubes that fit. Mike Iowa BTW #10 can handle 25 A do you need that much? ----- Original Message ----- From: To: Sent: Wednesday, June 06, 2007 2:10 PM Subject: Re: [TenTec] Gauge of wire from power supply question? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | Re: [TenTec] Gauge of wire from power supply question?, Paul Gates, KD3JF |
---|---|
Next by Date: | Re: [TenTec] TenTec Digest, Vol 54, Issue 7, Owen S. Garner |
Previous by Thread: | Re: [TenTec] Gauge of wire from power supply question?, MICHAEL SOUHRADA |
Next by Thread: | Re: [TenTec] Gauge of wire from power supply question?, Art Searle W2NRA |
Indexes: | [Date] [Thread] [Top] [All Lists] |