TenTec
[Top] [All Lists]

Re: [TenTec] V 2.062a Orion 565AT

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] V 2.062a Orion 565AT
From: "Dick Green" <wc1m@msn.com>
Reply-to: wc1m@msn.com,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 6 Jun 2007 12:13:59 -0400
List-post: <mailto:tentec@contesting.com>
I saw something like this during the brief time I had 2.062a loaded.
Transmitting a single dit fixed it. Next time it happens, try that and let
us know if it worked.

73, Dick WC1M

> -----Original Message-----
> From: Owen S. Garner [mailto:k1af@bellsouth.net]
> Sent: Tuesday, June 05, 2007 1:35 PM
> To: tentec@contesting.com
> Subject: [TenTec] V 2.062a Orion 565AT
> 
> Does any one have the same problem I have with V 2.062a?  When I
> attempt to change bands or modes after a few minutes of operation, all
> signals are lost from the audio and the band scope, yet the rest of the
> display appears normal.  Turning the Orion off, and back on after an
> hour or so, restores the signals, only to be lost again after a few
> minutes when attempting a band change.  Master resets do not help.  I
> reloaded V2.059, and the rig works normally,with no problems changing
> bands or modes.  Meanwhile, I am living with V 2.059
> K1AF

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>