TenTec
[Top] [All Lists]

[TenTec] Forum for rfsquared's "One Plug" remote software for OmniVII?

To: tentec@contesting.com
Subject: [TenTec] Forum for rfsquared's "One Plug" remote software for OmniVII?
From: "david feldman" <wb0gaz@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 05 Jun 2007 19:40:31 -0600
List-post: <mailto:tentec@contesting.com>
A friend has lent me his new Omni 7 for a few days to check out, set up and 
generally make ready.

While I was able to get the rfsquared.com remote software (with receive 
audio) working from a couple of other machines on the LAN here (locally), I 
am not able to receive audio over remote internet connection, even though I 
can get the remote connection to go active (I can control the radio, but not 
receive audio from it.) I'm puzzled by this, because port 49152 (default) is 
properly opened for incoming UDP in my internet firewall, and it seems only 
UDP is used for control as well as audio. Radio control works (can tune, 
change mode, watch S meter, etc. and I think this is using the same UDP as 
the audio path), but receive audio doesn't (no receive audio).

Not sure how to make use of some of the statistics fields shown in the 
software to help troubleshoot this.

Anyway, wondering if there's a gathering place for those working through 
remote access issues with the Omni 7 - I have the rig captive for just a few 
days before it goes to it's long-term QTH, and I'd love to get a handle on 
this before giving it up (so I can access it from there!)

73 Dave WB0GAZ wb0gaz@hotmail.com

_________________________________________________________________
Get a preview of Live Earth, the hottest event this summer - only on MSN 
http://liveearth.msn.com?source=msntaglineliveearthhm

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>