| To: | <geraldj@storm.weather.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers? |
| From: | "Steve Hunt" <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 21 May 2007 12:17:07 +0100 |
| List-post: | <mailto:tentec@contesting.com> |
Gerald, Not strictly true .... on my Corsair II the "attenuator" switch removes the pre-amp and "replaces" it with a 3dB pad :) Steve G3TXQ Don't know about the Omni V and VI, but the "attenuator" switch on the Corsair II actually removes the RF stage from the circuit. There is no attenuator. -- 73, Jerry, K0CQ, All content copyright Dr. Gerald N. Johnson, electrical engineer _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] V2.061f Issues, Ron Castro |
|---|---|
| Next by Date: | Re: [TenTec] (Orion) firmware update with serial port-less computer, George |
| Previous by Thread: | Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?, Dr. Gerald N. Johnson |
| Next by Thread: | Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?, Kevin Purcell |
| Indexes: | [Date] [Thread] [Top] [All Lists] |