My S-meter needle sits a little less than S-1 .... just at the
top end of the little black bar. This is with RF Gain at 100,
LCW, 600 Hz filter.
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Grant
Youngman
Sent: Saturday, May 12, 2007 12:13 PM
To: 'Discussion of Ten-Tec Equipment'; orion565@yahoogroups.com
Subject: [TenTec] 2.060b S-Meter "0"
I've discovered today that the s-meter "zero" position on my
orion with
2.060b installed is about S-1.5. With 1.3xx software installed
it sites
dead on S-1 where it is supposed to.
Can anyone with a v2 Orion and 2.060b confirm where the S-meter
sits with no
signal no antenna?
Thanks ... Grant/NQ5T
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|