TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] V2.060b Release Comments

from [Bob Henderson] [Permanent Link][Original]
To: "Carl Moreschi" <n4py@arrl.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] V2.060b Release Comments
From: "Bob Henderson" <bob@5b4agn.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 25 Apr 2007 20:45:05 -0000
List-post: <mailto:tentec@contesting.com> 
----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>

> The key is do you have to run the volume higher for headphones
> than speaker or lower or the same?  My volume works fine with the same
> volume setting for both headphones and speaker.
>
> I agree the smuck is not great but at least we now have QSK again.
>
> Carl Moreschi N4PY

I have AF gain lower on speaker.  However, even with AF gain at maximum 
there is absolutely no sign of the 'smuck' on speaker.  It is purely a 
headphone effect here.

Bob, 5B4AGN 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [TenTec] Fw: V2.060b Release Comments, Bob Henderson
Next by Date:  [TenTec] RFI, Computer, Omni IV+, John Huffman
Previous by Thread:  Re: [TenTec] V2.060b Release Comments, Carl Moreschi
Next by Thread:  Re: [TenTec] V2.060b Release Comments, Dick Green
Indexes:  [Date] [Thread] [Top] [All Lists]