Barb,
Try cycling the band switch back and forth thru
all positions. Don't spray tunner lub/cleaner on the
switch. So far I have fixed several tentec radios in
such a fachion. Remember the simple checks, is your
power supply voltage correct? A change in PS voltage
during transmit will cause major distortion in the
output signal.
Hope this helps. Are you using an electronic
keyer? A leaky transistor in a electronic keyer can
also cause CW distortion.
Take care, 73'S KA5SIW
--- Barbara Maloney <ac5p@sbcglobal.net> wrote:
> Hello group,
> Lately my Delta II has developed a distortion
> problem. CW signals will break into severe
> distortion both receive and transmit. SSB receive
> sigs do same. I dont transmit SSB. AM receive
> signals will have severe noise on the audio.
> Anybody have any clues or suggestions before I
> contact TT?
>
> Mike, AC5P
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
____________________________________________________________________________________
Never miss an email again!
Yahoo! Toolbar alerts you the instant new Mail arrives.
http://tools.search.yahoo.com/toolbar/features/mail/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|