All of a sudden My Omni VI(+1) began acting up.
When turned on from a cold start, the PBT is way off, I must turn it about
30 degrees to the Counter CLockwise in ALL MODES.
After 5 minutes or so it JUMPS to the "normal" setting (rather it is off
again and I must re center the control to hear as I normally would). It
doesn't drift, it SUDDENLY reverts to its proper state.
If, for example, you were copying a cw station it would disappear and you
would have to re-center the station with the control. It works fine until
turned off and allowed to get cold.
Has anyone seen this one? I searched and didn't find any in the archives.
Since it is in all modes, it should narrow it down some.
Thought I would check before I open it up.
Thanks, MArk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|