I know this is a silly request, but I am willing to pay shipping both
ways. I will only need it for a day or two. My problem is that I think
the 500 Hz filter is going 'South' in my Omni-C... probably a bad
crystal. This past weekend during the CW contest I noted noticeably
weakened signals when going to that filter position. So much so that
many normally marginal signals in the 2.4 or 1.8 kHz positions were
simply gone in the 500 Hz position. Anyway, before I go out and buy a
replacement filter I'd like to know if I have a problem or just
imagining a problem. My Corsair II does NOT attenuate like this, but as
a newer design it may have additional gain built in to compensate. As
its 500 Hz filter is on a different IF frequency I can't swap them.
Jerry, KG6TT
--
Ralph Jerald "Jerry" Volpe
Amateur Radio Operator KG6TT
ARRL Member & VE
FISTS 12304
788 Chestnut Drive
Fairfield, CA 94533
kg6tt@arrl.net
510 325-7724
707 399-8838 FAX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|