Check the wiring. Once in a while, Heil has been known to get the pins
mixed up. Also check for the usual in the mic and cables: cold solder
joints, broken wires or shields, etc.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Gary Strong" <gjstrong@comcast.net>
To: <tentec@contesting.com>
Sent: Sunday, January 28, 2007 9:21 AM
Subject: [TenTec] AM Radio in SSB transmission
>I purchased a Heil HM10 for my Orion II. Speaking with Heil, they said the
> appropriate cord was a modified Yaesu 8 piin cord, and as such I purchased
> it from Heil.
>
>
>
> I just hooked it up yesterday and while testing everything on a dummy
> load,
> I am getting a local AM broadcast station on my microphone audio. While
> not
> loud, clearly able to be heard. Before I open up the cord, has anyone had
> this problem? I understand the mike is grounded through the shell of the
> connector, so I did make sure it was tight.
>
>
>
> All equipment is grounded and appears to have no other problems.
> Obviously
> with all the threads on grounding, my setup is the typical ground rod,
> short
> #6 wire, to a single ground point setup. Any ideas?
>
>
>
> Gary
>
> KO0Q
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|