What kind of headphones are you using? Orions are a bit fussy about
impedances being too high or too low. 32 Ohms is apparently the best match.
As already pointed out, check all the menu settings under the "Audio"
button.
The other thought that comes to mind is that the AGC Hang (Menu/RX) time
should be set to something other than 00.00. For most CW/SSB work, settings
above 00.12 should work. Last week we had a discussion here about AM, which
requires hang to be set to at least 03.00.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Bill Gaines AD8P" <ad8p@wcoil.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, January 27, 2007 6:47 PM
Subject: [TenTec] Orion Receiver Distortion
>I just received my "new-to-me Orion" and everything was fine until the
>audio from the headphones started sounding all distorted. Like it was being
>overdriven. The speaker audio sounds great. I have no idea what I did or
>when I did it. I know I am not to use mono headphones and I don't. All I
>have are Heil stereo types.
>
> What did I do wrong and what can I do to fix it?
>
> Bill
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|