TenTec
[Top] [All Lists]

Re: [TenTec] Station Grounding

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Station Grounding
From: "dw" <bw_dw@fastmail.fm>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 27 Jan 2007 00:20:20 -0800
List-post: <mailto:tentec@contesting.com>
I'm just thankful that even though I'm short of a PHD, I've
never had the slightest bit of damage over 30 years of hamin.
Now watch the throttling I'm gonna get for daring to say that :)


On Sat, 27 Jan 2007 02:17:30 +0000, "Dave Heil" <k8mn@earthlink.net>
said:
> Some of the misinformation on this topic comes straight from Paul at 
> Ten-Tec.  After I had lightning damage and discussed the matter with a 
> local ham who is an electric company employee, I broached the subject 
> with Paul.  While not argumentative, he was insistent that radio station 
> grounds and power company grounds should never be tied together.
> 
> It was quite obvious from the damage done here three years back, that 
> lightning hit the power lines and entered my home via that means.  The 
> shack ground was not tied to the house's power ground.  It was obvious 
> that the difference in potentials between the two grounds caused most of 
> the damage.  Despite Paul's view, the two are now tied together with #00
> wire.
> 
> Paul has the opinion that not only should the two grounds not be tied 
> together, the radio equipment should be disconnected from *everything* 
> when not in use.  While I disconnect antennas, I'm not disconnecting my 
> transceiver from power and all other equipment each time I'm finished 
> using it.  It simply isn't practical.
> 
> Dave Heil K8MN
> 
> Mike Gorniak wrote:
> > Agreed! For the life of me, I will Never understand why there is so much 
> > debate in the Ham Radio Community regarding this issue. In the 
> > Professional World, there is no debate at all. We look very foolish to 
> > outsiders when we incessantly and incorrectly pontificate about matters 
> > that have already been settled from an engineering perspective. The NEC 
> > requires all grounds to be bonded. Just do it. You'll be a lot safer. As 
> > AA4NU suggests, Polyphasor is a good resource. Here's another:
> > 
> > http://www.nautel.com/Resources/Docs/Whitepapers/lightningprotection.pdf
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
-- 
  dw
  dw@sover.net

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>