I always use color 3 and only detect the flicker in some lighting contexts
and at extreme viewing angles. No flicker under normal room light, viewing
head on. Run my back light on medium. What I see flickering is the
gold/brown framing.
Bob K5SM
------------------------------
RM wrote:
>I'm running Color 3 on the Orion II without any flicker (with the backlight
>set to LOW). With the backlight set HIGH, I still do not see any flicker.
>
>Running the latest version of the OII software. Interesting since below
>said TenTec has it classified as a known issue.........Would like to
>understand the configurations that folks are observing the flicker.
>
>
>Ron, NU1U
>
>
>
I also use Color 3, backlight LOW. I can detect a slight flicker when I
key, using full power. It's most noticeable (still not very) when
looking at the blue highlighted MULTI function (RF Gain, usually, here),
but it can be detected in the main VFO's frequency readout.
This is SOOOOO trivial, guys!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|