John,
Each band button has 4 settings referred to as stacking registers. On my
radio, if I start with the "first" register for 20 meters, it is 14.035 LCW
900 Hz bandwidth. The second push is 14.070 USB 3000 Hz. The next is
14.167 USB 2350 Hz. The fourth is 14.329 USB 2350 HZ. If I press the
button again, I will be back to the CW register setting. These settings
will be there unless I am in one of them and change the setting. Then the
next time I come back to that register, it will be what ever I was using
when I left that register or band. I hope this makes sense to you. Look at
stacking registers in the manual.
73,
John
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John
Sent: Saturday, January 13, 2007 1:39 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] auto mode change
Hello all , I have a question . Is there anyway to set up the Orion to
automatically switch modes when it passes between band plans i.e.. is when
crossing over from ssb to cw etc ? thanks John
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|