TenTec
[Top] [All Lists]

Re: [TenTec] grounding

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] grounding
From: "M. Todd Miskel" <kt0dd@bresnan.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 9 Jan 2007 17:37:51 -0700
List-post: <mailto:tentec@contesting.com>
Doesn't a good earth ground help remove stray RF from the shack? along with 
ferrtie cores etc...
----- Original Message ----- 
From: "george fritkin" <georgefritkin@yahoo.com>
To: <tentec@contesting.com>
Sent: Tuesday, January 09, 2007 5:15 PM
Subject: [TenTec] grounding


> OK one more time..It is as simple as this...A balanced antenna up more 
> than 1/4 wavelength "sees" infinite impedance to ground,   So to save your 
> copper braid etc put your antenna up 1/4 wavelength and make certain it is 
> balanced at feed point, then you do not need any ground other AC safety 
> grounds.  Stray RF in the shack needs attention.  RF can kill with 
> prolonged exposure.  Other than poorly shielded gear, the two conditions 
> above cause RF problems
>
> George, W6GF
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.432 / Virus Database: 268.16.8/621 - Release Date: 1/9/2007 
> 1:37 PM
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>