Best thing is to check with TT itself, They know what they have done with
each supply and rig.
My own preference is to use the 963 supply as it will cut off easily on over
current, Had a couple instances when I was on 160 M and got off my center
frequency too far, the 963 would shut down before I noticed the mistake,
the Astron 35M would have kept delivering current till the finals became the
fuse....
Best wishes,
Rich
K5SF
>From: Mykeyw9@aol.com
>Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>To: tentec@contesting.com
>Subject: Re: [TenTec] Ten Tec 963 Current Overload Protection ?
>Date: Sun, 7 Jan 2007 23:18:46 EST
>
>In a message dated 1/7/2007 7:20:36 PM US Mountain Standard Time,
>W3ETC@comcast.net writes:
>I have read a couple of posts about Power Supplies and overload protection.
>I am using my Orion with an Astron SS-30M and so far no issues. Would I be
>better to switch to the TenTec 963, which I also have available but
>currently do not have in service ? Does it have the overload protection
>that others are talking about ?
>I think the TenTec power supplys do have overload protection. That's why
>their rigs don't. Better check this out but I would think one would be
>better
>off to use theirs.
>
>
>Mike W9UQB/7
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_________________________________________________________________
Your Hotmail address already works to sign into Windows Live Messenger! Get
it now
http://clk.atdmt.com/MSN/go/msnnkwme0020000001msn/direct/01/?href=http://get.live.com/messenger/overview
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|