I have MMTTY and a RigBlaster Plus and I can't seem to figure out how
to do this directly. I keep thinking that I should be able to do it
with the serial port connected to the RigBlaster plus and use the
"CW" output line for FSK, but I've had no luck; I think I read this
in the manual as well. Do you run yours directly though the
RigBlaster or do you use an NPN interface?
Kim Elmore, N5OP
At 12:06 AM 1/4/2007, you wrote:
I use MMTTY with the RigBlaster Pro and FSK. Never a problem with my O-II
except that if I happen to do a reset of the O-II (infrequent) I always
forget to reset the FSK sense to Mark High.
Dave K5WNV
----- Original Message -----
From: "Neal Campbell K3NC" <nealk3nc@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, January 03, 2007 6:54 PM
Subject: [TenTec] Orion2 bug in FSK
>I just wrote ditsnbits about this.
>
> We have been getting ready to play in the ARRL RTTY Roundup this
> weekend with Orion2's, using FSK.
>
> We have seen several times the situation where the software (and we
> have tried many programs although they all use MMTTTY as an engine)
> thinks it is triggering transmit, rx audio is muted on the O2 (like
> its transmitting) but it is not actually transmitting anything (no
> swr indication on the screen, no power deflection on the s meter, no
> sound coming from the monitor, etc.) We have found that if you just
> press the tune button and let it tune for few seconds and then
> everything works perfectly.
>
> We have seen it 5 or 6 times and spent a lot of time debugging comm
> ports, interface boxes, etc. but its a strangeness of the O2.
>
> Just wanted to let you know in case you want to join us this weekend!
>
> Neal
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|