TenTec
[Top] [All Lists]

Re: [TenTec] Omni6+ Amp Buffer

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Omni6+ Amp Buffer
From: "Ed, W3ETC" <W3ETC@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 29 Dec 2006 20:19:41 -0500
List-post: <mailto:tentec@contesting.com>
I personally think that it is very cheap insurance.  The Ameritron ARB 704
is $ 59 and it works fine with my setup.

73  Ed  W3ETC

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Stephen Crain
Sent: Friday, December 29, 2006 7:12 PM
To: TenTec@contesting.com
Subject: [TenTec] Omni6+ Amp Buffer

  Greetings all,
  I've purchased an Omni 6+. I will use it to drive an Ameritron AL-80B. 
  Is it wise to use an interface buffer? The manuals for both seem to
suggest one is not needed. Both send and use 12VDC low mA to ground. What
about transients and spikes? The Omni is supposed to have a rock solid ouput
to amp and the Ameritron has reverse voltage diodes. 
  Thanks for any and all comments,
  Stephen, KG0K
   

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>