Ok I just read where the OMNI VI opt3 is the same as the OMNI+ now I am
*really* getting confused. :0)
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Jim McDonald
> Sent: Saturday, December 23, 2006 9:32 PM
> To: 'Discussion of Ten-Tec Equipment'
> Subject: Re: [TenTec] Radio Control/Contesting??
>
> The option 3 mod was only done at the factory. You could ask
> if they still can do it. I recall there was a short window
> when the mod was first introduced and I had mine done, so it
> might be too late now.
>
> Jim N7US
>
>
> AD5VJ:
>
> >
> > Option 2 was same except it had the keypad changed to reflect
> > differences INSTEAD of stickers on keys.
> >
> > Option 3 was same PLUS added a new filter board and an additional
> > filter position.
> >
>
> OK so to move from an opt2 to an opt3 I plug in a new filter
> board and install a new switch on the front panel?
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|