>
> Option 2 was same except it had the keypad changed to reflect
> differences INSTEAD of stickers on keys.
>
> Option 3 was same PLUS added a new filter board and an
> additional filter position.
>
OK so to move from an opt2 to an opt3 I plug in a new filter board and install
a new switch on the front panel?
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of
> k8vf_mark@centurytel.net
> Sent: Saturday, December 23, 2006 9:05 PM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Radio Control/Contesting??
>
> http://www.qsl.net/tentec/
>
>
> This may help some. Check above link.
>
> Omni a/d were same except one had digital readout.
>
> Omni a/d series B changed filter schemes.
>
> Omni D series C added some bands, changed filter schemes. HAD
> SAME MODEL NUMBER AS OMNI D, essentially same rig.
>
> All had PTO's.
>
> Dont forget Omni V, Omni VI, Omni VI with possible options
> 1-2-or 3, Omni VI PLUS which was essentially an OMNI VI
> option 3-only it was sent from the factory NEW that way.
>
> Omni VI option 1 moved some functions to front panel which
> had been in menus. Allowed LP filter to operate in cw and ssb modes.
>
> Option 2 was same except it had the keypad changed to reflect
> differences INSTEAD of stickers on keys.
>
> Option 3 was same PLUS added a new filter board and an
> additional filter position.
>
> I am sure I missed something so before I get corrected, you
> are right .
> Sorry.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|